Drywall Stud Products

Product Description

Uses/Applications

Drywall studs are roll-formed from corrosion resistant steel and are primarily used for interior non-load bearing partition wall construction. Knurled flanges prevent screw "ride-up" which expedites the attachment of gypsum wallboard. Punchouts are strategically located to facilitate electrical conduit, plumbing and/or bridging if required.

Specifications

SIZES (Depths): 1 5/8 inch (162), 2.5 inch (250), 3 5/8 inch (362), 4 inch (400), 6 inch (600)

GAUGES (Mils): 25 (18), 22 (27), 20 (33)

LENGTHS: Stock length is readily available, cut to length upon request, six foot minimum

Complies with ASTM C-645

Refer to Truss General Notes

Complementary/Accessory Products

We sell a wide selection of framing accessories from wire mesh and vapor barriers, to form releases and footing chairs. Our steel fabrication facilities offer world class service and professional technical support.

Product Technical Information

Steel Stud Manufacturers Association - Product Technical Information

Steel Con trusses are designed by Steel-Con personnel using the advanced Keymark IT software. Our trusses are sealed by a licensed professional engineer. As with traditional wood trusses, the overall building design - including such items as bracing, hold downs and sheathing attachments - is the responsibility of the engineer/architect of record.
Non-Structural Stud Section Properties (refer to page 6)
Limiting Wall Height Tables (refer to pages 12-15)
Ceiling Span Table (refer to pages 42-43)